Hoe gebruik je Levelit? - Levelit tiling to perfection

STeP 1 : SLIDE THE CLIPS UNDER THE TILE

After applying the adhesive to the tile, slide the clips under the tile. You should slide one or more clips on each side of the tile, depending on the size of the tile. Tap the tile.Place the next tile after placing the spacers.

* Multiple spacers may be needed for each side of the tile,based on the tile’s size.
* We recommend it to use two spacers on each side of the tile, for tiles that are around 20 cm.
In any case, 1.5 mm spacers are used for 1.5 mm tile jointsand 2 mm for 2 mm joints.

STEP 2 : TWIST THE CAP ON THE CLIP 

Twist with your hand the caps on the clips, that where slid under the tiles.

STEP 3 : TURN THE CAP UNITL TIGHTENED

Turn the cap until the end and tighten it to level the tile.

STEP 4 : REMOVE THE CLIP

After tightening the cap, let it dry for 24 hours.

Once the adhesive is totally dry, you can remove the cap and clip from the surface. Break the clip with a rubber hammer of a foot in the direction of the joint.

* If you use a quick drying adhesive, wait until the adhesive has completely dried out.

STEP 5 : TURN THE CAP OF THE BROKEN CLIP

The caps can be reused by turning them out of the clip.

STAP 5 : SCHROEF DE CAP VAN DE GEBROKEN CLIP

Levelit kopen of verdeler worden?

Levelit kopen of verdeler worden?

Wil je graag Levelit aankopen, een offerte opvragen, verdeler worden, of ons gewoon een vraag stellen omtrent Levelit? Neem dan contact met ons op en wij bezorgen u zo snel mogelijk een antwoord